Well Pump Electricity Cost Calculator
A 1 hp well pump drawing about 1,000 W for two hours a day costs roughly $11 a month at the U.S. average rate — usually a small line on the bill.
Average draw while running
Effective full-power hours
Sets the price per kWh
Estimated cost
$11.07/ month
$0.36 per day
$132.86 per year
- Per hour
- $0.18
- kWh / month
- 61
- Rate used
- 18.2¢
- vs U.S. average
- —
Estimate only. Well pump at 1000 W for 2 h/day, priced at your state’s average residential rate. Your utility and plan may differ — see methodology.
How long it actually runs
A well pump does not run continuously. It cycles to refill the pressure tank, typically 30–60 minutes of total run time for a family of four, depending on tank size and water use. Irrigation, a leaky toilet flapper or a failing pressure tank can multiply that.
| Setup | Draw | Hours/day | Monthly |
|---|---|---|---|
| 1/2 hp, typical | 500 W | 2 | ≈ $6 |
| 1 hp, typical | 1,000 W | 2 | ≈ $11 |
| 1.5 hp, typical | 1,500 W | 3 | ≈ $25 |
| 1.5 hp, irrigation | 1,500 W | 6 | ≈ $50 |
When the pump becomes visible on the bill
A failing pressure tank makes the pump short-cycle — starting every few minutes instead of every few hours. Start-up draws a surge several times the running wattage, so frequent cycling both wears the motor and raises consumption. A pump that runs constantly and never shuts off usually means a leak or a stuck switch.
Constant-pressure pumps change the math
Variable-frequency drives hold pressure by running the pump slowly rather than cycling on and off. They use less energy than a comparable fixed-speed pump and eliminate the start-up surge, but the drive electronics add cost and a failure point. On deep wells, the energy difference can be meaningful.
Frequently asked questions
How many watts does a well pump use?
A 1/2 hp pump draws roughly 500 W running, 1 hp about 1,000 W, with a much higher brief start-up surge.
Why did my electric bill jump after a plumbing repair?
Air in the lines or a pressure tank that lost its charge can make the pump cycle rapidly. That is worth checking.
Does a well pump use more than a city water connection?
Usually a few dollars a month — trivial next to heating and cooling, unless you irrigate heavily.
Does a deeper well cost more to pump?
Yes — lifting water further requires more work, so the same household uses more kWh from a 300-foot well than a 60-foot one.
How can I tell the pump is running too much?
Listen for frequent short cycles; a healthy system runs in longer, less frequent bursts.
Keep going
The cost of one appliance rarely tells the whole story. These are the calculators people open next.